Smart Home Guides

How to Automate a Water Pump with a Level Sensor

Filling the rooftop tank by hand, or forgetting the pump running, wastes water and electricity. When you automate water pump control with a level sensor, the pump starts when the tank is low and stops when it is full, with no guesswork and less wear on the motor.

automate water pump - ROCKSON Water Level Controller

Two Ways to Automate Water Pump Control

Option 1: Dedicated Level Controller

A controller such as the Rockson water level controller uses probes or sensors to switch the pump automatically between set levels. It works without internet or an app.

Option 2: Smart Sensor and Smart Relay

An ultrasonic sensor sends the level to the Tuya app, and a smart relay or DIN relay switches the pump based on scenes. You also get remote monitoring and alerts. See smart DIN rail devices and EPT sensors.

Automate Water Pump Control in 6 Steps

  1. Check the pump power and current rating.
  2. Choose a relay or contactor rated for the pump load.
  3. Install the level sensor on the upper tank and, if needed, a dry run sensor on the lower tank or well.
  4. Wire the relay to control the pump through a contactor if the load is high.
  5. Create scenes: pump on below a set level, off above a set level.
  6. Test several cycles and adjust the levels.

Protecting the Pump

  • Stop the pump if the lower tank or well is empty.
  • Add a minimum off time to avoid rapid on and off cycles.
  • Use proper motor protection in the panel.
  • Check the pump regularly for noise or heat.

Energy Saving Tips

Schedule pumping during EDL or solar hours when possible, and avoid running the pump on expensive generator time. Combine this with smart home for power cuts strategies.

Common Mistakes

  • Using a relay below the pump current rating.
  • Skipping dry run protection.
  • Mounting the sensor above the inlet.
  • Setting on and off levels too close together.

Read how to monitor your water tank level from your phone and see our water level meters. For background, see this pump overview.

Wiring Example with a Contactor

For pumps with high starting current, the smart relay should not switch the motor directly. Instead, the relay switches the coil of a contactor, and the contactor switches the pump. This protects the relay and gives a safer installation. Your electrician should also include motor protection suitable for the pump.

Setting On and Off Levels

  • Start the pump when the upper tank drops to around 30 percent.
  • Stop the pump when the tank reaches around 90 percent.
  • Leave a gap between levels to avoid frequent cycling.
  • Add a dry run stop based on the lower tank or well level.

Monitoring Pump Activity

With a smart relay, the app logs when the pump runs. Long or frequent runs can reveal leaks, a stuck float valve or a failing pump. Combined with energy data, you can see how much each pumping cycle costs.

Maintenance of an Automated Pump System

Check the sensor face and relay terminals twice a year, clean any dust or insects from the tank lid, and review the pump log in the app for unusual patterns. If the pump starts more often than usual without higher water use, look for leaks in the pipes or a faulty non return valve.

Automate Water Pump FAQ

Do I need an electrician?

Yes. Pump circuits carry high current and must be wired safely.

Can I control the pump from my phone?

Yes, with a smart relay in the Tuya app.

What if the internet goes down?

A dedicated controller keeps working. App based scenes need the gateway and router online.

Can one sensor control two pumps?

Yes, with two relays and separate scenes.

Automate water pump control with WeVolt and keep water flowing without effort.

Need help choosing? WeVolt is based in Beirut, delivers across Lebanon and answers product and wiring questions by phone and WhatsApp. Browse our full shop or contact our team for a free recommendation.